Q: What settings should be made on the Victron inverter in order to work with the Solar MD battery?
top of page
Forum: Forum
To see this working, head to your live site.
3 Comments
bottom of page
top of page
Forum: Forum
Featured stories
bottom of page
A: Set all batteries to, ensure the BMS-Can port interface is set to 500kbit/s, and check that the port monitor displays a steadily increasing value for both TX packets and RX packets.
To set up your Victron inverter to work with the Solar MD battery, follow these steps:
Battery Type: Set the battery type to "Lithium" in the inverter settings.
Battery Voltage: Match the nominal voltage of the Solar MD battery.
Charge Parameters: Input the charge parameters provided by Solar MD, including charge voltage and current limits.
Communication: Ensure the Victron inverter is correctly communicating with the Solar MD battery using the appropriate communication cable and protocol.
Safety Settings: Enable relevant safety features such as over-voltage and under-voltage protection.
Refer to the manuals of both the Victron inverter and Solar MD battery for specific details.
Always refer to the Solar MD battery specifications and the Victron inverter's user manual for the most accurate and up-to-date information on configuring the inverter for use with the battery. Improper configuration can lead to damage to the battery or inverter, so it's important to ensure that the settings are correct.